I've been finding Windows 10 in FreeBSD's version of VirtualBox unbearably slow, so decided to give bhyve a try. Much of this is taken from vm-bhyve's Quick start guide.
The first steps are fairly straightforward. Install vm-bhyve. You can use pkg for this.
pkg install vm-bhyve bhyve-firmware
The firmware package is recommended when having a guest, such as Windows, that can use UEFI. It's a meta package that also installs a couple of other uefi bhyve packages.
Create your vm directory. We'll just call it vm for purposes of this tutorial. If using zfs then use zfs create pool/vm if using UFS, then mkdir /vm can be used. Now that we have our main directory, we can add these lines to /etc/rc.conf. (In this case, let's assume we used UFS, and the directory is under /vm).
Now run vm init. This will create the required subdirectories under /vm. Next we want the templates. We can just get the Windows one, but we may as well get all the sample ones that were installed when we install vm-bhyve.
cp /usr/local/share/examples/vm-bhyve/* /vm/.templates
Note the dot in front of .templates, it's a hidden file.
Now we have to create a switch which the vm will use for networking. We'll keep this as simple. The switch will be called public and attached to our main network card. Say the main card connecting you to the Internet is em0.
vm switch create public vm switch add public em0
We need a Windows10 (or whatever--in this case, we'll assume Windows-10) iso. You can put it where you like, for convenience, I would put it in the same directory that you have for the vms. We'll assume it's called Windows-10.iso.
We can now begin to create the guest. The -t refers to type, so in this case, we use -t windows. The -s refers to size. The default size is 20G for Windows, but we'll make it 40G. You can call it whatever you want, in this case, we'll call it winguest.
vm create -t windows -s 40G winguest
If you wish to reconfigure from the defaults, now run vm configure winguest and a file will open showing the various defaults. For example, memory is set at 2G. You may wish to raise this, or the number of processors which is set to 2.
Once created, we can begin the installation. We can use a vncviewer, e.g., remmina, tightvnc, or anything else you prefer.
vm install winguest /Windows-10.iso
You will see a message that it has booted. Now to see what's going on, you will need a vncviewer. It uses port 5900, so if you were using tightvnc's vncviewer the command would be vncviewer localhost:5900. This should take you to the Windows install. It will reboot once or twice.
When complete, it reboots again. (You probably have to reconnect the vncviwer each time you reboot). This time it will go through setup, asking location, choice of keyboard, and so on. When complete, you should have a working Windows 10 installation.
In the future, when you want to run it, you can start it with the command vm start winguest. You will need to run a vncviewer on port 5900 to view its screen. I have found it to run far more smoothly than Windows in FreeBSD's VirtualBox. There are various improvements you can make, such as changing the default e1000 virtual NIC with virtIO, but as I only need Windows for a few quick things, I haven't looked into that.